Notes on reverse engineering efforts for the NeoDen 3 TM245P Pick and Place machine.
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
Morgan 'ARR\!' Allen 2e12543ce1 some data dumped from the ds1052 scope 5 months ago
data some data dumped from the ds1052 scope 5 months ago
eevblog_teardown notes dump 5 months ago
images scope trace of bit 5 months ago
schematics more schematic labeling 5 months ago
README.md values, labels, spacing, PDF 5 months ago

README.md

RE-TM245P

The end goal of this project is to convert a partially broken TM245P Pick and Place to OpenPNP while replacing as little hardware as possible. The difficulty in this is that the feeders and everything on the head are CAN bus controlled. In an effort to not replace these parts, the protocol will need to be reverse engineered.

Approaches

Smoothieware Port

The Charmhigh conversion undertaken by others approaches leaving the controller largely intact and flashing a Smoothieware port onto the STM32. The repo notes suggest the Charmhigh used an STM32F4, which the TM245P also uses. Specifcally the STM32F407ZGT6.

https://github.com/mattthebaker/Smoothieware-CHMT

'Decap'

In this approach the entire head unit will be bypassed. Ideally this could be accomplished by utilizing the existing IDC connector on the power/comm sub-board.

'CAN Bus'

Communication is done over the VP230 CAN Transceiver, though it doesn't look to be real CAN. Instead the STM32 USART1 is connected so it's doing Syncronous UART over CAN. So it's really just using the VP230 for differential signaling.

Reading

https://www.eevblog.com/forum/manufacture/neoden-tm245p-teardown-and-upgrade/